` Everybody , After I put a sign on the crane , use photoscan After the software builds the three-dimensional model of the crane , How to get the coordinate data of the mark points on the model , Or how to get the size of the crane model , Because I need to compare the coordinate data of the mark points on the model with the coordinate data measured by the total station to determine the accuracy of the model . I beg you to help me point out , Thank you very much for that ！`

版权声明

本文为[CSDN Q & A]所创，转载请带上原文链接，感谢

https://cdmana.com/2021/12/20211207202212955C.html